Welcome to Suzhou Maili Electrical Appliance Co., Ltd.

  • tik-tok-3
  • instagram-line-3
  • youtube-fill-4
  • twitter-x-fill-3
  • facebook-fill-2-3
Leave Your Message

BS-153 Dual Battery Isolator Kit 24 Volt 200 Amp with Voltage Sensitive Relay Boat for RV Car Truck caravan

Model: BS-153
Working Principle
Dual battery isolator makes up an easy-to-install isolated charging system to charge your auxiliary battery without the risk of discharging your start battery.
A Dual battery isolator allows you to charge 2 or more different batteries from a single alternator safely, keeping the main
starting battery isolated from the second auxiliary battery.

Main Functions
1.Charge and discharge two batteries isolated :
When the engine starts and the alternator works, the voltage of the main battery rises to the connect voltage, the Dual Battery Isolator starts to connect the main and auxiliary batteries, allowing two batteries to be simultaneously charged in parallel; when the voltage of main battery drops and be lower than the disconnect volt, the Isolator will disconnect the two batteries to protect the main battery from discharging. This means that the auxiliary battery CANNOT discharge or draw power from your starting
battery.

2. Assist starting the engine:When the vehicle needs to start (if the voltage of main battery is too low), the battery isolator can supply current to the engine by forcibly connecting two batteries in parallel, and start the vehicle successfully.

    Product Features

    A combination of a pure sine wave inverter, automatic battery charger and AC auto-transfer switch.
    CE CB SAA ROHS Approved PASSPOWER 3000w Low Frequency Inverter with 90A Charger102

    Optional Functions

    • A
      Battery Overheat protection 
    • B
      Complete the system's personalized settings by the LCD display control panel (optional) or by communications protocol software easily and quickly.
    • C
      The inverter can charge the battery automatically when AC power or generator power is available without turning on the inverter.
    • D
      E. Priority inverter mode
    • E
      The inverter can be turned on and used at -40 °C operating temperature.(Customized)
    CE CB SAA ROHS Approved PASSPOWER 3000w Low Frequency Inverter with 90A Charger101

    Parameters

    Model

    QSP3000-212 QSP3000-224 QSP3000-248 QSP3000-112 QSP3000-124 QSP3000-148

    Rated output power

    3000W

    Peak power

    300%

    DC Input Voltage

    13VDC

    26VDC

    52VDC

    13VDC

    26VDC

    52VDC

    DC Input Voltage Range

    10.8~16.0(*2=24v;*4=48V)

    AC Output Voltage

    220VAC±3%

    110VAC±3%

    Output Frequency

    50/60HZ±0.5%

    AC Output Voltage Range

    165~265VAC

    80~140VAC

    Standby power loss

    12W

    22W

    30W

    14W

    24W

    32W

    Output waveform

    Pure sine wave (THD <3%)

    The Max. Efficiency

    95%

    Switching Time

    <8ms

    DC Charging Current

    12V:90A/60A/30A/0A      It can be set at the factory or set via the (optional) LCD display
    24V:50A/30A/10A/0A      It can be set at the factory or set via the (optional) LCD display
    48V: 30A/20A/10A/0A     It can be set at the factory or set via the (optional) LCD display

    Type Of Battery

    AGM/GEL/OPZV/LFP/Flooded/INR  It can be set at the factory or set via the LCD display (optional)

    PV Module (optional)

    Adapt to the battery voltage automatically.

    The charging current :30A (set in factory before shipment)

    Failure Indication

    LED flash

    Protection Level

    Inverter overload protection, output short circuit protection must be restarted
    Over temperature protection, low voltage protection, over voltage protection, automatic recovery
    Mains mode overload protection, when short circuit, the fuse burns down.

    Remote switch (optional)

    RJ45-digital color display ; charging voltage and charging current can be set

    Temperature / Humidity

    -15~50°C/20~90%RH (It can be customized &used at -40°C operating temperature)

    Cooling Way

    Forced air cooling

    Weight (KG)

    21.7

    Product Size (mm)

    488*257*157(L*W*H)

    Application

    application_02

    Make an free consultant

    Your Name*

    Phone Number

    Country

    Remarks*